Loading Door Disassembly; Loading Door Reassembly; Control Panel Name Plate Decal; Name Plate Removal - Dexter Laundry T-350 Parts & Service Manual

Loading Door Disassembly

Step 1: Remove the loading door as outlined above. Lay the door on a flat surface with the glass down.
Step 2: While holding down on the door glass, lift up on the door ring and roll back the lip of the gasket
with your fingers.
Step 3: Work all the way around the gasket and the glass is out.

Loading Door Reassembly

Step 1: Lay the door ring face down on a flat surface. Start the glass into one side of the door gasket.
Step 2: Use one hand underneath to push the gasket out and the other hand on the top pulling the
gasket in place.
Step 3: The front lip of the door gasket should be checked for proper seating.

Control Panel Name Plate Decal

The name plate on washer front is adhesive backed.
Control Panel Name Plate Removal
The name plate may be removed by simply peeling it off.

Re-Installation of Name Plate

Step 1: Remove any remaining glue from the control panel.
Step 2: Before removing the paper backing from the name plate, check fit to the control panel. The
program push buttons are the locating guides.
Step 3: Remove the paper backing from the right side of the name plate, position it on the panel and
press right end into place. Peel the backing from the left end and press into place.

Bolt Torque Chart

Bolt Size
1/2"x 1 1/4" bolt
5/8"x 1 1/2" bolt
1/2"x 1 1/4" bolt
5/8"x 2 1/2"bolt
3/8"x 1 1/2" bolt
108
Part # 8533-104-001 1/18
Bolt Torque Chart
Where Used
Tub End of Bearing Hsing. 9545-017-009
Tub End of Bearing Hsing. 9545-060-001
Mtg. of Tub to Cradle Asy. 9545-017-009
Mtg. of Tub to Cradle Asy. 9545-060-001
Tub Back Ring to Tub Back 9545-029-003
Torque
70-110 ft/lbs
120-150 ft/lbs
70-110 ft/lbs
120-150 ft/lbs
45-80 ft/lbs