Dexter Laundry T-350 Parts & Service Manual page 46

PERMANENT DRYER CONTROLLER PROGRAMMING EXAMPLE
REQUIREMENTS: Dry a load with 50 minutes of actual heat at 195°F and three minutes of cool down.
The following procedure will show you how to permanently modify the existing dry cycle 1 pro-
gram for one cycle of drying. It is based on the assumption that the factory defaults have not been per-
manently change. If they have been changed, the steps of this procedure will be the same, but the values
that are displayed will be different. The amount of times that either the UP or DOWN touch pad switch
of the dryer controller must be pressed and released may also be different.
If you want the change to be temporary (for only one dry cycle), go to the "TEMPORARY DRYER
CONTROLLER PROGRAMMING" section of this manual.
1)
touch pad switch on the dryer controller until the L.E.D. for dry cycle 1 is illuminated.
2)
dryer controller will not change.
3)
controller display will change from "L0Ad" to "Prog". You have now entered the perma
nent programming mode. The dry time L.E.D. will remain on and the programming L.E.D.
will illuminate.
4)
programming L.E.D. will remain on, the dry time L.E.D. will illuminate, and the dryer controller will
show the number "35".
5)
number "53".
6)
The dry time L.E.D. and programming L.E.D. will remain on, the dry time L.E.D. will switch off, the
temperature L.E.D. will illuminate, and the dryer controller display will show the number "180".
7)
shows the number "195".
8)
time L.E.D. and the programming L.E.D. will remain on, the temperature L.E.D. will switch off, the
cool down L.E.D. will illuminate, and the dryer controller display will show the number "5".
9)
shows the number "3".
10)
time L.E.D. and the programming L.E.D. will remain on, the cool down L.E.D. will switch off, and
the dryer controller display will change to "Prog".
11)
will remain on, the programming L.E.D. will switch off, and the dryer controller display will change
to the word "LOAd".
program will remain in the dryer controller memory until the default settings push
button is pressed. This default setting push button is located on the component side of the dryer
controller printed circuit board at the lower middle side.
46
Part # 8533-104-001 1/18
PROCEDURE:
After the load has been placed in the dryer, press and release either the UP or DOWN
Press and release the PROG touch pad switch on the dryer controller. The display of the
Immediately, press and release the UP touch pad switch on the dryer controller. The
Press and release the SELECT/ENTER touch pad switch once. The dry time L.E.D. and
Press the UP touch pad switch 18 times until the display of the dryer controller shows the
Press and release the SELECT/ENTER touch pad switch of the dryer controller once.
Press and release the UP touch pad switch three times until the dryer controller display
Press and release the SELECT/ENTER touch pad switch of the dryer controller. The dry
Press and release the DOWN touch pad switch twice until the dryer controller display
Press and release the SELECT/ENTER touch pad switch of the dryer controller. The dry
Press and release the STOP touch pad switch of the dryer controller. The dry time L.E.D.
The dryer is now ready for the new modified dry cycle to start. This modified dry cycle 1