Dexter Laundry T-350 Parts & Service Manual page 40

or opening the dryer loading door will stop the dry cycle and not clear it. If you press the STOP
touch pad switch on the controller and then open the dryer loading door, the dry cycle will not be
cleared. However, if you open (or open and close) the dryer loading door and then press the
STOP touch pad switch on the dryer controller, the present dry cycle will be cleared and the word
"LOAd" will appear on the dryer controller display.
ler printed circuit board.
controller display shows and operates in the Fahrenheit or Celsius mode. This jumper is
labeled as TEMP SELECT and has three pins.
heit, which is indicated by the letter C for Celsius and the letter F for Fahrenheit.
troller circuit board, is used for choosing either a reversing or non-reversing type of dryer.
This jumper is labeled as REV and NON-REV. This jumper must be in the non-reversing position,
which are the bottom and middle pins. If the jumper is in the reversing position, the heating part
of the dry cycle will not operate properly. The dryer will not reverse direction either.
dryer controller circuit board, is used to reset all five of the dry cycles to the factory default set
tings. It is labeled as DEFAULT SETTINGS. Even the dry cycles that have been modified using
the permanent programming procedure will be changed back to the factory default settings
when using this push button. This push button must be pressed and held for at
least three seconds with power applied to the dryer controller circuit board.
40
Part # 8533-104-001 1/18
During the dry cycle, either pressing the STOP touch pad switch on the dryer controller
There are two jumpers and one push button on the component side of the dryer control
The jumper located at the lower right side of the circuit board controls whether the
The bottom and middle pins are for Celsius and the top and middle pins are for Fahren
The other jumper, located at the upper right side of the component side of the dryer con
The push button, which is located at the lower middle side of the component side of the