Washer Operating Instructions - Dexter Laundry T-350 Parts & Service Manual

WASHER OPERATING INSTRUCTIONS

Safety Door Lock
This machine is equipped with a Safety Door Lock that locks the door closed from when the cycle is
started until the cycle is complete. The door lock prevents opening the door for up to 3 minutes if the
power is interrupted during the cycle.
Microprocessor
Prior to operation, the micro computer should be set to display the cycle to be given to the user.
NOTE: Should a power loss occur during cycle and when power returns, PUSH will be displayed in
window and customer must push the START button to continue the cycle.
Starting the Washer
A. Load the items to be washed in the cylinder and latch the door securely. Be sure clothing does
not get caught between the door gasket and tub front when closing the door.
NOTE: To close the door the handle must be in the horizontal position and then moved
to the vertical position. After moving the door to the closed position, the handle must be
turned down to the vertical position to latch the door for machine operation.
B. Make the appropriate cycle selection for the wash load by pushing the UP and DOWN arrows on
the touch pad. Preprogrammed Cycles 1,2,3,4,5, or 6. Each cycle is completely programmable and
for instructions see next section in this manual.
C. To manually add wash compounds, pour low-sudsing powdered detergent into the detergent
dispenser on front of the machine. Rinse conditioners may also be added to the dispenser. The
correct location of each is shown on the dispenser lid.
D. To manually add bleach in Rinse, pour bleach in opening. Bleach light will come on during the
wash bath only (location shown on dispenser lid) in top or front of washer.
E. To start the washer, push the green START button
To pause for an extended soak, push the red STOP button for 1 second. To continue the cycle,
F.
push the green START button.
G. To stop and clear the wash cycle, hold the red Stop
button for 8 to 10 seconds.
H. If automatic chemical injection systems are being
used, make sure that chemical hoses are inserted
correctly in the injection port located at rear corner
at red cover. Hoses must be inserted long enough
to reach down to water trap.
Detergent
Measurements
1/4
Cup
Triple Load SWD Washer
Part # 8533-104-001 1/18
25