Tub Back, Bearing And Cylinder Assembly - Dexter Laundry T-350 Parts & Service Manual

Tub Back, Bearing and Cylinder Assembly

Removing the Washer Tub Assembly from the Washer Frame
Step 1: Remove the left and right lower front panel screws that retain the panel to the chassis.
Step 2: Remove the Drain Hose from the bottom of tub assembly.
Step 3: Remove Overflow and Tub vent hoses at rear tub back.
Step 4: Remove the pressure switch hose from the bottom of the switch.
Step 5: Disconnect the door lock wires from all switches and the door lock gear motor. The following
illustration of their locations should be consulted.
Step 6: Disconnect pull rod between solenoid and door lock assembly.
Step 7: Disconnect the wires to the drain valve at the bottom of the machine.
Step 8: Remove 4 (four) bolts at outer tub ring and slide complete assembly out front . (Note: very heavy,
use appropriate devices )
109
Part # 8533-104-001 1/18