Dexter Laundry T-350 Parts & Service Manual page 43

TEMPORARY DRYER CONTROLLER PROGRAMMING EXAMPLE
REQUIREMENTS: Dry a load with 40 minutes of actual heat at 185°F and five minutes of cool down.
The following procedure will show you how to temporarily modify the existing dry cycle 1 program
for one cycle of drying. It is based on the assumption that the factory defaults have not been permanently
changed. If they have been changed, the steps of this procedure will be the same, but the values that are
displayed will be different. The amount of times that the UP or DOWN touch pad switches of the dryer
controller must be pressed and released may also be different.
If you want the change to be permanent, go to the "PERMANENT DRYER CONTROLLER PROGRAMMING"
section of this manual.
After the load has been placed in the dryer, press and release the UP or DOWN touch
1)
pad switch on the dryer controller until the L.E.D. for dry cycle 1 is illuminated.
2) Press and release the CYCLE touch pad switch on the dryer controller. You will see the
number "35" on the dryer controller display. The programming L.E.D. and dry time L.E.D. will be
illuminated.
3) Press and release the UP touch pad switch on the dryer controller 10 times so that the
display will show a flashing "45". When the UP touch pad switch is pressed the first time,
the number "36" will be flashing on the dryer controller display. Each number after that will also
flash.
4) Now, press and release the SELECT/ENTER touch pad switch on the dryer controller.
The number "45" will stop flashing, the dry time L.E.D. will switch off, the dryer controller
display will now show "180", the temperature L.E.D. will illuminate, and the programming
L.E.D. and dry cycle 1 L.E.D. will remain on.
Press and release the UP touch pad switch on the dryer controller one time so the con
5)
troller display will show a flashing "185". Each press of the UP touch pad switch will increment
the temperature by five degrees.
Now, press and release the SELECT/ENTER touch pad switch on the dryer controller.
6)
The number "185" will stop flashing, the temperature L.E.D. will switch off, the dryer con
trol display will now show a number "5", the cool down L.E.D. will illuminate, and
the programming L.E.D. and dry cycle 1 L.E.D. will remain on.
Press and release the SELECT/ENTER touch pad switch on the dryer controller, since the
7)
desired cool down time is five minutes. After you press the SELECT/ENTER touch pad switch,
the cool down L.E.D. and programming L.E.D. will switch off, the controller display will remain at
"5", and the cycle 1 L.E.D. will remain on.
You are now ready to start the new dry cycle. The new dry cycle will be in effect for one dry cycle
only. After the dry cycle is done, or if the STOP touch pad switch on the dryer controller
is pressed and released twice, consecutively, the cycle 1 program will revert to the factory
default settings.
If you press the START touch pad switch on the dryer controller, the controller display will change
from the number "5" to the number "45" and dry cycle 1 will begin.
PROCEDURE:
43
Part # 8533-104-001 1/18