Appendix C. Installation And Wiring Diagrams - GE XMTC User Manual

ADD JUMPER FROM U3
PIN 2 TO U3 PIN 5
78
P7
SEE DETAIL "B"
SEE DETAIL "B"
NOTES:
1. ASSEMBLE PER IPC-A-610 AND/OR PANAMETRICS STANDARD 957-002.
2. INSTALL C29 AND C30 ON SOLDER SIDE OF BOARD AS SHOWN.
C29 MAY EXTEND OVER THE EDGE OF THE PCB 0.14" MAX.
3. TRIM J6 AND J7 LEADS TO 0.04 INCHES MAX HEIGHT ABOVE THE PCB.
4. INSTALL VR3 AT CR2 LOCATION AND INSTALL VR4 AT CR4 LOCATION.
XMTC User's Manual
DETAIL "A"
1
FOR 710-1276 REV A, B, C ONLY
FOR U3 REWORK
SEE DETAIL "A"
SEE NOTE 4
SEE NOTE 2
COMPONENT SIDE VIEW
FOR 710-1276 REV A, B, C ONLY
1
REF
SEE NOTE 2
DETAIL "B"
SOLDER SIDE VIEW
INSTALL C35 ATOP
OR ASIDE R3
NUMBER
SOLDER SIDE VIEW
CHANGES TO THIS DRAWING MAY REQUIRE PRIOR AGENCY (FM/CSA)
AUTHORIZATION. REFER TO CERTIFICATION DRAWING 752-107
AND CONTACT THE CERTIFICATION ENGINEER.
GROUPS
DESCRIPTION
01 STANDARD
02 TC
03 OX
04 OX + PRESS

Appendix C. Installation and Wiring Diagrams

REF ONLY
79