GE XMTC User Manual page 123

GE
Sensing
We,
declare under our sole responsibility that the
to which this declaration relates, are in conformity with the following standards:
• IECEx 60079-0: 2011 & EN 60079-0: 2012
• IECEx 60079-1: 2007 & EN 60079-0: 2007
• EN 50281-1-1: 1998
• EN 61326-1: 2006, Class A, Table 2, Industrial Locations
• EN 61326-2-3: 2006
• EN 61010-1: 2001, Overvoltage Category II, Pollution Degree 2
Other standards Used:
• EN 50014: 1997 +A1, A2, A3
• EN 50018: 2000
following the provisions of the 2004/108/EC EMC, 2006/95/EC Low Voltage and 94/9/EC ATEX Directives.
Where products were initially assessed for compliance with the Essential Health and Safety Requirements of the
ATEX Directive 94/9/EC using earlier harmonized standards, a subsequent review has determined that "technical
knowledge" is unaffected by the current harmonized standards listed above.
The units listed above and any ancillary equipment supplied with them do not bear CE marking for the Pressure
Equipment Directive, as they are supplied in accordance with Article 3, Section 3 (sound engineering practices and
codes of good workmanship) of the Pressure Equipment Directive 97/23/EC for DN<25.
Billerica - June 2013
Issued
GE Sensing
1100 Technology Park Drive
Billerica, MA 01821
XMO2 Oxygen Analyzer
XMTC Thermal Conductivity Binary Gas Transmitter
USA
DECLARATION
OF
CONFORMITY
DOC-0004, Rev. B