Table of Contents
Advertisement
264 Appendix H Command Interpreter
Table 65 IPSec commands
Command
rmAddrType
rmAddrStart
rmAddrEndMask
rmPortStart
rmPortEnd
btNatActive
btNatType
btNatAddrStart
btNatArEnd
swSkipOverlapIP
<on|off>
adjTcpMss
<off|auto|user
defined value>
contivityDial
contivityDrop
contivityState
contivitySplit
contivityTimecnt
<0~65535>
exemptHost
display
load <index>
active <Yes|No>
N0115789
Description
Sets the remote address type.
<0:single |
1:range |
2:subnet>
Sets the remote starting IP address.
<IP>
Sets the remote ending IP address or
<IP>
subnet mask.
Sets the remote starting port number.
<port>
Sets the remote ending port number.
<port>
Turns branch tunnel NAT address
<Yes | No>
mapping on or off.
Sets the type of NAT address mapping.
<0:single |
1:range |
2:all>
Sets the branch tunnel NAT starting IP
<IP address>
address.
Sets the branch tunnel NAT ending IP
<IP address>
address or subnet mask.
Turn this option on to have the device
allow rules with overlapping source and
destination IP addresses.
Sets the adjust TCP Maximum Segment
Size.
Initiates the Contivity Client VPN
connection.
Ends the Contivity Client VPN
connection.
Displays information about the Contivity
Client VPN connection.
Sets the Contivity Client keep-alive
interval (in seconds).
Uses the exemptHost commands to
configure specific IP addresses that are
not to be part of a VPN tunnel.
Displays the exempt host settings.
Loads an exempt host.
Enables or disables an exempt host.
Advertisement
Table of Contents
