Configuring What You Want The Business Secure Router To Log; Table 84 Log Categories And Available Settings - Nortel BCM50e Configuration

302 Appendix K Log descriptions
Go to the command interpreter interface (see
Interpreter" on page 243
commands).
Configuring what you want the Business Secure Router to
log
Use the sys logs load command to load the log setting buffer that is used to
configure which logs the Business Secure Router is to record.
Use sys logs category followed by a log category and a parameter to decide what
to record.

Table 84 Log categories and available settings

Log Categories
access
attack
error
ike
ipsec
javablocked
mten
upnp
urlblocked
urlforward
Use the sys logs save command to store the settings in the Business Secure Router
(you must do this in order to record logs).
N0115789
for information on how to access and use the
Available Parameters
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1
0, 1
0, 1, 2, 3
0, 1
Use 0 to not record logs for that category, 1 to record only logs for
that category, 2 to record only alerts for that category, and 3 to
record both logs and alerts for that category.
Appendix H, "Command