Restore Configuration; Restore Using Ftp - Nortel BCM50e Configuration

Table 40 General commands for GUI-based TFTP clients
Command
Binary
Abort
Refer to
configurations that disallow TFTP and FTP over WAN.

Restore configuration

This section shows you how to restore a previously saved configuration. Note that
this function erases the current configuration before restoring a previous back up
configuration; do not attempt to restore unless you have a backup configuration
file stored on disk.
FTP is the preferred method for restoring your current computer configuration to
your Business Secure Router since FTP is faster. note that you must wait for the
system to automatically restart after the file transfer is complete.

Restore Using FTP

For details about back up using FTP and TFTP, refer to
on page
Chapter 15 Firmware and configuration file maintenance 165
Description
Transfer the file in binary mode.
Stop transfer of the file.
Chapter 17, "Remote Management," on page 183
Warning: Do not interrupt the file transfer process as this can
permanently damage your Business Secure Router.
160.
BCM50e Integrated Router Configuration - Advanced
for information about
"Backup configuration"