Table of Contents
Advertisement
250 Appendix H Command Interpreter
Table 61 Sys commands
Command
parse
brief
version
view
wdog
switch
cnt
romreset
server
pwderrtm
upnp
active
config
display
firewall
N0115789
[[start_idx], end_idx]
<filename>
[on|off]
[value]
access
<telnet|ftp|web|icmp|snmp|
dns> <value>
load
disp
port <telnet|ftp|web|snmp>
<port>
save
secureip <telnet|ftp|
web|icmp|snmp|dns> <ip>
[minute]
[0:no/1:yes]
[0:deny/1:permit]
[0:deny/1:pass]
Description
Displays detailed packet details of the
packet range specified.
Displays a brief listing of packet
contents.
Displays the RAS code and driver
versions.
Displays the specified text file.
Turns the watchdog firmware
protection feature on or off.
Sets (0-34 463) or displays the current
watchdog count (in 1.6 sec units).
Restores the factory default
configuration file.
Use these commands to configure
remote server management.
Sets the server access type.
Loads server information.
Displays server information.
Sets the server port.
Saves server information.
Sets server secure IP address.
Sets or displays the password error
blocking timeout value.
Activates or deactivates the saved
UPnP settings.
Allows users to make configuration
changes through UPnP.
Displays UPnP information
Allows UPnP to pass through the
firewall.
Advertisement
Table of Contents
