Error Messages With The "Filehandler" Program - Siemens MOBY series User Manual

Error Messages
8.2 Error Messages with the "FILEHANDLER"
Program
The following table lists the messages which can occur with the filehandler. A
filehandler error message looks like this.
Type of error
(see chap. 8.1)
Exact filehandler error
Filehandler Description of Error, Its Cause and Correction
Error
A006 Unknown command. Command identifier KK is illegal.
A011 With 1st command block: DBN not 1
With next block: KK or DBN incorrect
A015 Checkbyte error while receiving from S5
A016 Command from other sender is being processed.
A020 Wrong number of characters in the telegram
B001 Error in the connection to the SLG
Read head defective
C002 Error on RAM of the MDS. Replace MDS and perform
FORMAT.
C006 Presence error. MDS in boundary area.
C007 Parameterization error during FORMAT. Command
cannot be interpreted.
C008 Too many sync attempts. Field interference on read
head.
C009 Too many sending errors
C010 CRC sending error
C011 FORMAT. CRC error while receiving.
C012 FORMAT. MDS cannot be initialized.
C013 FORMAT, timeout. MDS in boundary area.
C014 FORMAT, not initialized. Check Extras/Parameter.
C015 CMD address error. Check Extras/Parameter.
C016 ECC error. Format MDS again. Disable ECC mode.
C017 General driver error
E-66
The filehandler error is shown in the same way
as the filehandler on the SIMATIC. The error
message has one alpha character followed by a
3-position number. Most of the error codes are
identical with the error numbers of all MOBY file-
handler interfaces.
(5)J31069-D0126-U001-A5.1-7418
R 01.04
Type of
Error
Protocol Protocol
errors
SLG errors
MDS errors
STG Hand-Held Terminal