Moby I Setup; Moby E Setup - Siemens MOBY series User Manual

R 01.04
4.5.5

MOBY I Setup

S Mem size:
S Tag type:
S ECC:
S MDS507:
S Sample rate:
4.5.6

MOBY E Setup

S Key A/B:
S Mode:
S Antenna:
STG Hand-Held Terminal
(5)J31069-D0126-U001-A5.1-7418
Specifies the memory size of the MDS to be processed
This setting also defines the memory area in the editor.
MDS memory addresses which exceed the memory size
cannot be addressed.
Distinguishes between RAM/FRAM and EEPROM
The RAM/FRAM setting shows an empty MDS support
battery on the STG.
Turns the ECC driver on and off
The purpose of the ECC driver is described in the
documentation of the MOBY interface.
This parameter must only be set to "yes" when the
MDS 507 is used. With the MDS 507, the dialog battery
is scanned and indicated as "Status" when it is empty.
The scan time is only relevant when the MDS 507 is
used with an ASM 420. The setting range is 0.1 sec to
6.3 sec. The default value (0.5 sec) usually does not
have to be changed.
You can switch between the "MOBY key" and the
"B transport key for MIFARE data memory."
The MOBY key is always standard. The "B" setting
permits the MIFARE MDS to be processed in its status
on delivery. (The B key must be in its original state.)
Only for MOBY E SIM (cf. chapter 6.6):
Switches the SIM from cyclic mode to continuous mode.
Command processing is much faster in continuous
mode.
You can switch between card and pill.
The "MOBY D/E/F/I/U" Programs
E-33