System Reset; Expanded Functions - Siemens MOBY series User Manual

R 01.04
Note
Since the standard SIM uses cyclic operation, it takes much, much
longer to process a read/write command than with the STG read
head. The EXTRAS/MOBY E Setup/MODE command can be used
to switch the SIM to the faster read mode. This command must be
repeated each time SIM is turned on.
ASM 420/I/V:
This settings permits an ASM 420/RS 232 to be connected to the hand-held
terminal. The connection cable must comply with the specifications in the
ASM 420 documentation. In ASM 420 mode, the MOBY V driver is always en-
abled during the "MOBY I" program. SLG 65 can be used on the ASM 420 with
this. Use of MOBY I SLGs is limited.
Assignment of the RS 232 interface on the hand-held terminal:
Pin Designation
2 TxD
3 RxD
5 Gnd
6.7

System RESET

The hand-held terminal executes a system RESET when the device is turned
on for the first time after the batteries have been installed. This RESET is the
same as a hardware RESET.
A system RESET can also be triggered by hand. To do this, press the
Ctrl + Del (Shift + Esc + Del on the PSION with the numerical keyboard) simul-
taneously.
During the system RESET:
S The MOBY STG application is started again.
S Data stored in flash memory are always retained (drive A: or B:).
S The data in RAM memory (drive "RAMDRIVE:") are retained. However,
these data will be lost if all batteries (including lithium cell) of the PSION are
removed.
STG Hand-Held Terminal
(5)J31069-D0126-U001-A5.1-7418

Expanded Functions

key +
E-59