System Setup; Set The Communication Parameters; Set The Miscellaneous Parameters; Set The Digital Input Parameter - Xylem FST Installation, Operation And Maintenance Manual

5 System Setup

Introduction
The following configurations are done on the PrimeGaurd 2 control panel.
For the PV102P configuration parameters, refer to PV102P control panel
documentation.

5.1 Set the communication parameters

1. Go to MAIN PARAMETERS > COMMUNICATION PARAMETERS.
2. Set the communication parameters:
Parameter
MODBUS SERVER ADDRESS
RS485 SERVER BAUD RATE
PROTOCOL SELECTION

5.2 Set the miscellaneous parameters

1. Go to MAIN PARAMETERS > MISCELLANEOUS PARAMETERS.
2. Set the miscellaneous parameters:
Parameter
Mechanical Engines
Electronic Engine

5.3 Set the digital input parameter

1. Go to MAIN PARAMETERS > DIGITAL INPUT PARAMETERS.
2. Set the digital input parameter:
Control panel
PrimeGuard 2
PV102P
This parameter is used to start and stop the pump remotely.

5.4 Set the analog input parameters

1. Go to MAIN PARAMETERS > ANALOG INPUT PARAMETERS.
2. Set the following analog input parameters.
These parameters are used for optional devices that are pressure
transducers and flowmeters.
FST Installation, Operation, and Maintenance Manual
Setting
247
38400
Modbus
Setting
None
J1939 PrimeGuard HRS or J1939 ECU Engine HRS
Parameter
DIGITAL INPUT 1
DIGITAL INPUT 4
5 System Setup
Setting
Remote call to run
Remote call to run
25