System Components - Xylem Aquavar SPD SPD20050 Instruction Manual

SYSTEM COMPONENTS

Section 2
Please review the SPD components and insure that you have all the parts and are familiar with their names. Be
sure to inspect all components CentriPro supplies for shipping damage.
SPD Variable Speed Controller:
1. SPD Controller
2. Pressure Transducer with Cable
3. Conduit Plate Caps
WARNING
DO NOT power the unit or run the pump until all electrical and plumbing connections,
WARNING
Hazardous
especially the pressure sensor connection, are completed. The pump should not be run dry.
voltage
All electrical work must be performed by a qualified technician. Always follow the National
CAUTION Electrical Code (NEC), or the Canadian Electrical Code (CEC) as well as all local, state and
Hazardous
provincial codes. Code questions should be directed to your local electrical inspector or code
Pressure
enforcement agency. Failure to follow electrical codes and OSHA safety standards
may result in personal injury or equipment damage. Failure to follow manufacturer's installation instructions
may result in electrical shock, fire hazard, personal injury, death, damage to equipment, unsatisfactory
performance and may void manufacturer's warranty.
Controller Product Code Information
SPD Y XXXX F
F = with Output Filter for Submersible Pump Applications
BLANK = without Filter for Above Ground/Centrifugal Pump Applications.
4 Digits for HP
5 HP
7.5 HP = 0075
10 HP = 0100
15 HP = 0150
20 HP = 0200
25 HP = 0250
30 HP = 0300
1 Digit for Input Voltage
230 volt = 2
460 volt = 4
575 volt = 5
SERIES
Page 4
= 0050