Universal Remote Control MSC-400 Programming Manual page 77

RFX-250 RF SENSOR
The RFX-250 receives narrow-band radio signals from compatible narrow-band RF remote controls and relays
them via a connecting cable to the MSC-400. The narrow-band RF technology and advanced protocol used in
the RFX-250 improves reliability and extends receiving range. The compact size and detached design enables
the RFX-250 to be placed in discrete locations, away from RF interference generated by system components
(when necessary).
RFX-250 RF Sensor Features
21 Antenna – One flexible antenna, receives RF signals from MSC compatible remotes. The antenna
can be rotated and angled to optimum reception position.
22 RF Out (Mini Jack) – One three-circuit 3.5 mono mini jack provides power to the RFX-250 and
sends understood RF commands to the MSC-400. This jack can be connected to either of the RF IN's
on the MSC-400 rear panel. POLARITY: TIP=+5VDC; RING=data; SLEEVE=GND.
23 RF Out (Plug-In) – One three-pin plug-in connector terminal provides power to the RFX-250 and
sends understood RF commands to the MSC-400. This terminal can be connected to either RF IN on
the MSC-400 rear panel.
24 RF LED – One red LED flashes when the RFX-250 is receiving RF signals from a MSC compatible
remote. This LED will also turn on in a range from low glow flicker to full on constant, when RF
noise is present. This is useful in troubleshooting for positioning the RF Sensor in a location clear of
RF interference (LED off).
25 Power LED – One red LED illuminates to indicate the RFX is powered from the MSC-400.
Reference: Features and Parts Type in Section Title
RFX-250 RF Sensor
69
M
S
C
4
0
0
M
A
S
T
E
R
S
Y
S
T
E
M
C
O
N
T
R
O
L
L
E
R