Universal Remote Control MSC-400 Programming Manual page 31

6 Click Save. Then a confirmation window stating how many devices were
imported will appear. The devices will appear under Connected Devices
within the Treeview.
7 Click on Ok. Click on
With this programming, all of the IR commands associated with these devices while setting up the
remote will all now have been imported to the CCP MSC Project.
8 Click on any Connected Device, such as the DVD, to open the device. Then double click on the
Function page. The Connected Device IR Command window will open with a table of all IR com-
mands for that device, broken down by hard keys and lcd pages, also known as soft keys. You'll use
these Connected Device windows to quickly record smart macros later.
The Connected Device Window opens when you double click the function page in Tree View.
Program Menu Step #2 - Devices & Routing
This section will assign each device to a dedicated IR output on the MSC-400. When assigned, the MSC-400
will ONLY send a Connected Device's IR Commands to the IR PORT ASSIGNED. This gives much more precise
control over the IR level delivered to the component and enables you to control identical components. There is
an option to send a device's IR commands to ALL Ports for troubleshooting purposes, however this should be
avoided since all the emitters will be flooding the equipment location with IR, reducing reliability.
TIP - In the example system, AVR (A/V Receiver), Tuner 1 and Tuner 2 are all
assigned Port 1. This particular receiver has two internal tuners and in the system
configuration the tuners have been setup as sources to be directly selected in Listen,
but the IR commands for the tuners must be directed to the AVR, Port 1.
Type in Section Title Devices & Routing
to close the window.
23
M
S
C
4
0
0
M
A
S
T
E
R
S
Y
S
T
E
M
C
O
N
T
R
O
L
L
E
R