Universal Remote Control MSC-400 Programming Manual page 52

44
5 Drag and drop the IF/ELSE Bracket where you want it. In this case, we want it to sense the Cable
box, so we drag it above the Cable[Power} step in the macro.
U
6 Now, drag the Cable (power) step inside the IF statement like this:
S
I
N
G
After you drag it, the IF statement should look like this:
C
C
P
E
D
7 Double click the IF line in the macro window. The IF setting window will appear.
I
8 In the Type area , select the Sensor radio button.
T
O
R
T
9 Within the Value area, using the Pull down list boxes, do all of:
O
a)
b)
P
c)
R
O
G
R
A
M
With these selections, when the Watch Cable TV Macro is triggered, the MSC-400 will look at Master Controller
Sensor Input 1 to determine if the Cable box is OFF. If it is, the MSC-400 will output the TV Power Command.
If the Cable Box is already ON, the MSC-400 will execute the empty ELSE statement (since it is empty, nothing
will happen and the Cable Box will stay on)..
Select Master from the upper left drop down field. (You would select Slave only in a double
MSC-400 system when you wanted to use the sensors of the 2nd or slave MSC-400)
Select the SENSOR from the upper right drop down field. (Sensor 1, Cable Voltage Sensor)
Select which state should trigger the IF action within the lower left drop down field. (If the
Cable box is Off), then Click Ok. The configuration will appear in the IF line
in the Macro window.
Type in Section Title IF/Else Statements