Summary of Contents for Universal Remote Control MS-C400
Page 1
Test Report No.: GETEC-E3-06-067 FCC Part 15 Subpart B APPENDIX H : USER’S MANUAL EUT Type: Master system controller FCC ID: OZ5URCMSC400...
Page 2
MSC-400 System Narrow Band RF Remotes Trigger Automation of RS-232, IR and Relay Controlled Components and Systems MSC-400 Master System Controller High performance audio video systems can include IR (infrared controlled devices such as Satellite and Cable set top boxes, DVD players etc.), RS-232 (serial controlled devices such as projectors, surround sound receivers and media servers), and Relay and Voltage controlled devices (such as lights, drapes, curtains and blinds).
Page 3
MSC-400 System Control Capabilities New Narrow Band RF Transmission & Reception plugged into the components switched outlet and then connected from the Master System Controller to optimize freedom from Control up to 12 Devices via IR - Controls Any audio video system, by its very nature, includes to a URC VS-100 Voltage Sensor, the MSC-400 can detect RF Interference and speed installation.
Instead of a simple macro, the MSC-400 intelligently tests each component to see whether it is on or off, then sends the exact commands needed to reconfigure the system. As a result, the system responds perfectly to the user, as if an invisible engineer was concealed in the system cabinet, operating the system for them. Hardware Designed for Professional Installers - Equips You with Instant Diagnostic Tools Installing and programming the MSC-400 Master System Controller is sped enormously by a combination of...
Page 5
M S C - 4 0 0 S y s t e m Q u i c k R e f e r e n c e G u i d e M S C - 4 0 0 S y s t e m Q u i c k R e f e r e n c e G u i d e Power LED indicates USB 1 LED indicates that MSC-400...
Page 6
M S C - 4 0 0 S y s t e m Q u i c k R e f e r e n c e G u i d e M S C - 4 0 0 S y s t e m Q u i c k R e f e r e n c e G u i d e MSC-400 Master System Controller Rear Panel IR and RS232 Outputs Standard Emitter for...
Need help?
Do you have a question about the MS-C400 and is the answer not in the manual?
Questions and answers