Universal Remote Control MSC-400 Programming Manual page 73

2 Add a second MSC-400 base station.
3 A model property window opens.
4 Select a RFID and check the box for slave of and select the primary MSC-400.
5 Click Ok.
6 Highlight one of the MSC-400 base stations from the House Designer and select a port.
7 To set RFID when using TX-1000 or MX-900 with More than 6 Devices IR Devices on Either con-
troller, set the Primary RFID only. Use any RFID from ID11to 1F for IR Control from Ports 1-11.
8 To set RFID when using MX-3000 or MX-950 with More than 6 IR Devices on Either controller, set
the Primary and Secondary RFIDS. Use any two RFIDS from ID 01 to 0F for IR Control from Ports 1-
11.
NOTE: The Instructions in Steps 6-7 relate to IR Control from Ports 7-11. If RS232 Devices are controlled via
Ports 7-11, then any RFID can be used for any remote and the Secondary RFID does not need to be set in Step
7.
9 Within the Serial Port Setting page, select (check mark) the Port 12 to Slave MSC-400 box. The Port
12 Setting line will gray out.
10 Click Ok.
11 To Save, In the CCP MSC Editor Menu Bar, click File, then click Save.
12 To download to the MSC-400 Master Controller, with the PC connected to the USB1 Port on the
MSC Master, Download by doing either of:
a) In the CCP MSC Editor Menu Bar, click Communications, then click Send to Remote.
b) In the CCP MSC Editor Menu Bar, click Program, then click Download.
Master/Slave Systems Type in Section Title
65
M
S
C
4
0
0
M
A
S
T
E
R
S
Y
S
T
E
M
C
O
N
T
R
O
L
L
E
R