Universal Remote Control MSC-400 Programming Manual page 30

22
Program Menu Step #1 - Import Remote Control Devices
This step will import the IR Commands for the devices to be controlled by the MSC-400. All physically con-
nected devices to the MSC-400 should be imported to the CCP MSC Editor. The remaining devices, which are
U
not physically connected to the MSC-400, will be controlled locally by the remote control.
S
1 To Import Devices, do any one of:
I
a)
N
b)
G
C
C
P
E
D
2 The Import Device window will appear, empty.
I
T
O
R
T
Browse Button
O
P
R
O
3 In the Import Device window, click the Browse button. The Open window will appear.
G
4. Navigate to where Project Files are saved. Click the file for the remote that was programmed with
R
the IR commands and click Open.
A
5 The Import Device window will populate with the devices that were programmed in the remote proj-
ect. Check all boxes for the devices that are to be controlled by the MSC-400.
M
NOTE - It is not necessary to check Listen and Watch unless IR commands have been associated with the
Pages for those buttons. Also note that in the example, CD is not checked. The CD Changer is going to be con-
trolled via RS232. RS232 devices will be added and configured in later steps. See Section: Adding and
Programming RS-232 Devices for additional information on creating RS232 controlled devices in CCP MSC
Editor.
Import Remote Control Devices
In the CCP MSC-400 Editor Menu Bar, click Program, then click Import Remote Control
Devices.
In the CCP MSC-400 Editor Model Designer Treeview, right click on Connected Devices. In
the pop-up, click on Import Remote Control Devices.
Program Menu
Type in Section Title
Import Device Window
Model Designer Treeview