Universal Remote Control MSC-400 Programming Manual page 49

8 In the Connected Device Block, select the device being controlled (Cable) using the Pull-Down.
9 Sequentially press the Numeric buttons for the channel being cond (502). As '0' and '2' are pressed
the Interstep Delay is automatically inserted into the Favorite Channel Smart Macro.
NOTE - Some Cable Boxes and Satellite Receivers require a '0' or '00' before double or single digit channel
numbers and others may require an 'Enter' Command. Be sure to add '0s' and 'Enters' when necessary.
10 Repeat Steps 7-8 for each Favorite Channel Smart Macro in the List.
11 Click the Close button, (X) when all Favorite Channel Macros have been programmed.
11 To Test, in Treeview, click the '+' next to Favorite Channels Group to expand the list and click a
Smart Macro in the list. The macro will appear in the Smart Macro window.
12 With the PC connected to the MSC-400 USB1 Port, click the Test button in the Smart Macro win-
dow.
13 Make corrections to the macros if needed.
14 To Save, In the MSC Editor Menu Bar, click File, then click Save.
TIP - The Favorite Channel Tool can also be used to insert sequences of channel
commands step Delays in any Smart Macro.
Type in Section Title IF/Else Statements
41
M
S
C
4
0
0
M
A
S
T
E
R
S
Y
S
T
E
M
C
O
N
T
R
O
L
L
E
R