Universal Remote Control MSC-400 Programming Manual page 33

Optional Step - Adding IR Devices
Normally, you don't need to add any devices, since you have already imported them from the remote control.
Use this step should you need to control an IR device that is needed for macros but not needed on the remote
control for the end user (for example a matrix video switcher).
NOTE - Though some steps are similar, there are additional steps to adding and configuring RS232 Devices.
See Section: Adding RS232 Devices for complete instructions on creating RS232 controlled devices in CCP
MSC Editor.
6 In the Devices & Routing window, click the Add New Device button. The New Device window will
appear.
Devices & Routing
7 In the Device Name field, type the device name as it is to appear in the model designer treeview
under connected devices.
8 In the Device Type field, select IR Database.
9 In the Target section, select IR PORT 1-12 or All as appropriate.
10 Click Ok to Add the New Device. The new device will appear in the Devices & Routing window.
11 In the Devices & Routing window, click Save to save the settings and add the new devices to the
modl designer tree view.
12 Click on the X located at the upper right hand corner of the Devices & Routing window to close.
NOTE - Clicking the close button (X) in the Devices & Routing window will close the window without saving
settings.
Type in Section Title Adding IR Devices
New Device
25
M
S
C
4
0
0
M
A
S
T
E
R
S
Y
S
T
E
M
C
O
N
T
R
O
L
L
E
R