Universal Remote Control MSC-400 Programming Manual page 38

30
To Manually Code RS232 Commands:
1 In CCP MSC Editor Model Designer Treeview, double click the Connected Device for which RS232
U
commands are to be added. Note: All RS232 devices are represented with an S in front of it and all
IR devices are represented with a IR .
S
2 Double click on the Function list Funcs. The Connected Device window will appear.
I
N
G
C
C
3 In the Connected Device window, double click on a command to open the connected data-serial
P
window.
E
D
I
T
O
R
T
O
4 Add a description name of the command to the Description field.
5 In the Data Block, select: ASCII, HEX or DECIMAL as defined
P
in the manufacturer's protocol, then enter the command string
for the selected function.
R
O
NOTE 1 - ASCII must be entered EXACTLY (including spaces) as the
command is to be sent. Use \x to indicate that the characters immediately
G
following should be interpreted as a hex byte. Example: PWON\x03
R
NOTE 2 - Hex bytes MUST be separated by a comma. 0x and h notation
A
may be used but are not necessary. Example: FE,36,20,03 or 0xFE,0x36,0x20,0x03 or FEh,36h,20h,03h
M
NOTE 3 - Decimal should be entered as values separated by commas. Example: 128, 2, 21
NOTE 4 - If the manufacturers protocol requires a carriage return, double click on the RS232 device within the
Model Designer Treeview and select the Properties window. Check the box to add a carriage return or
uncheck it if the carriage return is not needed.
Coding RS232 Commands Type in Section Title
Connected Data - Serial