Mode; Zero; Lb/Kg; Tare - Intercomp CS750 User Manual

MODE

The Mode button cycles through the scale set-up menu (Mode Menu) when in normal
run mode. When in calibration mode, use the button to toggle through the calibration
menu. Refer the "Mode Menu" and "Calibration Menu" sections for further details.

ZERO

The ZERO button is used to display a zero weight when the scale shows a non-zero
value with no weight on the hook. If ZERO is pressed with weight on the hook, the
weight becomes the zero condition for the scale. This can be useful to cancel the
weight of any weighing fixtures, such as containers, chains or cables. When the weight
is removed, a negative weight shows until the system is zeroed again. If "Motion Detect"
(see Calibration Menu) is enabled, the "ZERO" command will be rejected when a
change in weight is detected. The weight must be allowed to stabilize before the zero
command is accepted.
NOTE: The scale has a feature called Auto Zero Tracking (AZT) that corrects slight
zero changes during normal operation. If small weights are added slowly, the
scale will zero them off.

Lb/Kg

The Lb/Kg button toggles the weighing system between pound (English) and kilogram
(SI metric) units of measure. The current unit of measure is shown in the top left of the
indicator screen.

TARE

Pressing the TARE button will set the TARE equal to the current gross weight of the
total load suspended on the scale and then switch the display to net weight. The NET
indicator light is located below the indicator screen. The net weight is equal to the gross
weight minus the TARE weight. If TARE is pressed when a TARE is already set, the
display will briefly show the current TARE weight before returning to net weight display.
The TARE weight can only be set if the current gross weight is positive.
Clearing the TARE:
Press both the TARE and ZERO buttons to reset the TARE
to zero and return the scale to the GROSS weighing status.
Page 9 of 31
CS750 User Manual
Rev E, April 2018