Setting The Mode Menu Parameters - Intercomp CS750 User Manual

Mode Menu
Press the mode button to access the Mode menu. The screen will display "". If
"" is displayed, the calibration button should be pressed to return to normal RUN
mode. RUN mode will allow entry into the Mode Menu when mode is pressed again.
(Enter "5" for the "" entry to bring up Mode Menu.)
It may be necessary to enter a number (up to 5 digits). This is required when the current
number is displayed with a flashing number (right hand digit). The flashing number may
be incremented by pressing the Lb/Kg button or decremented by pressing the ZERO
button. To move one digit to the left, press the TARE button. When the number has
been entered, press the Mode button. Settings are saved each time Mode is pressed to
advance the menu. The scale can then be turned off.
Step

Print
. Back light

Set Point 1
 Set Point 2
.  Average rate
. Average Threshold
 Auto Off
 Print Mode

Printer Baud rate
 Scale ID
 Protocol
 Radio Enable

Radio Channel
.
Radio Network ID
.
Radio Encryption Enable Yes or no

Radio Encryption Button
.
Restore Radio Defaults

Setting the Mode Menu Parameters

1. Press the mode button to access the Mode menu. The display will show "".
This will allow the user to activate the print function by selecting "" or bypass
printing by selecting "". Press either the zero button or the lb/kg button to
toggle the display. When the desired setting is displayed press the mode button
to continue through the mode menu.
Function
Yes or no
On, off, or Auto
0 to 19999
0 to 19999
1 to 120
1 to 10000
000 = off, 1 to 240
0 = On-demand, 1 = Continuous
1200, 2400, 4800, 9600, 19200,
38400, 57600, or 115200
1-190
, , ., or 
Yes or no
01 to 12
0 to 65534
0 to 65534
0 or 3
Page 12 of 31
CS750 User Manual
Rev E, April 2018
Note Default
















