Motion Detection System - Intercomp CS750 User Manual

CS750 User Manual
Rev E, April 2018
Accum / Total Use
To enable the accumulating total function, press the "ACCUM TOTAL" button when a
load is placed on the scale. The screen will briefly show ".". This message
indicates the first accumulation has been calculated. Each subsequent accumulation
will briefly display ".X". The "X" element of the equation denotes the number of
accumulations that have been calculated during the weighing operation.
Accumulation Errors
The scale will not accumulate when the weight displayed is negative, zero or if motion is
detected on the scale. The message "." with error icon will be displayed if any of
these conditions are present. If motion is detected, the "MOTION" icon will also be
displayed. After a successful accumulation the scale must return to zero before
accumulation of the next weight can initiated. If an accumulation of the next weight is
attempted before allowing the scale to return to zero, the message "." with error
icon will be displayed.

Motion Detection System

The scale has a motion detection system that can be enabled or disabled using the
"Calibration" menu. Refer to the ", Motion Detect" step of the "Calibration Menu"
section. When the motion detect function is enabled, any load motion detected will
disable the zero, TARE, print and accum functions. When accumulating, the message
"." with the "MOTION" icon will be displayed. When attempting to zero, print, or
TARE the scale, the display will show "" and the "MOTION" icon.
Page 16 of 31