Accum / Total Use; Accumulation Errors; Motion Detection System - Intercomp CS3000 User Manual

not accessible to view and will always show as "00000". If you don't want to
change the key enter "00000" to leave it unchanged. All scales and indicators in
a system must be set to the same encryption key setting in order to communicate
with each other. When the desired number is displayed, press the Mode button
19. The display will show "rF.dEF". Press the Mode button. The display will show "0"
with the number flashing. The flashing digit may be incremented by pressing the
Lb/Kg button or decremented by pressing the ZERO button. Setting the number
to 3 will restore the default radio settings. All other numbers will have no affect
on the radio set-up. When the desired number is flashing, press the Mode
button. The scale will return to normal weighing.

Accum / Total Use

To use the accumulating total function, press the "ACCUM TOTAL" button once a load
is placed on the scale. The display will briefly show "AC. 1" indicating that the first
accumulation has been taken. Each subsequent accumulation will briefly display
"AC. X". (X will be the number of the accumulation that has taken place)
The "PRINT" functions will be covered after this section.

Accumulation Errors

The scale will not accumulate when the weight is negative, zero, or if the weight is in
motion. A display message "Ac.Err" with error icon will be displayed if any of those
conditions are present. (If in motion the "MOTION" icon will also be displayed.) After a
successful accumulation the scale must return to zero before you accumulate the next
weight. If you attempt to accumulate the next weight before allowing the scale to return
to zero, a display message "Ac.Err" with error icon will be displayed.

Motion Detection System

The scale has a motion detection system that can be enabled or disabled from the
"Calibration" menu. See "Calibration Menu" section for instructions in setting the motion
detection system.
When enabled, any motion of the load will disable the zero, tare, print, and accum
functions. When accumulating, the message "Ac.Err" with the 'MOTION' icon will be
displayed. When attempting to zero, print, of tare the scale the display will show "--- "
with the 'MOTION' icon.
Page 13 of 35
CS3000, Users
Rev A, January, 2011