Table of Contents
Advertisement
17. Materials
Monitor/Viewfinder
Do not push hard on the monitor.
0
This may cause irregular coloration or malfunction.
If the camera gets cold in the cold place, the picture on the monitor/viewfinder will be
0
slightly darker than usual at first when you turn the camera on.
When the interior of the camera warms up, this will return to normal brightness.
Extremely high precision technology is employed to produce the Monitor/Viewfinder
0
screen. However there may be some dark or bright spots (red, blue or green) on the
screen. This is not a malfunction.
Though the Monitor/Viewfinder screen parts are produced with highly controlled
precision technology, some pixels may be inactive or always lit.
The spots will not be recorded on images on a card.
Lens
Do not push hard on the lens surface.
0
Do not aim the lens at the sun or strong light sources.
0
The concentrated light may cause fire or damage.
Soiling on the lens surface (water, oil, fingerprints, etc.) may impact image quality.
0
Before and after use, lightly wipe the lens surface with a soft, dry cloth.
When the camera is not being used, attach the lens cap and lens rear cap to prevent
0
dust and dirt from adhering to or entering the camera.
To protect the lens contact points A, do not do the
0
following.
These may cause a malfunction.
– Touch the lens contact points.
– Soil the lens contact points.
– Place the lens with its mount surface facing
down.
To improve the dust and splash resistant
0
performance of the interchangeable lens
(S-R24105), a lens mount rubber is used in the mount.
– The lens mount rubber will leave scuff marks on the digital camera mount, but this
does not impact performance.
– To replace the lens mount rubber, contact Panasonic.
474
Advertisement
Table of Contents
