Panasonic Lumix DC-S1 Owner's Manual page 444

Table of Contents

Advertisement

16. Connecting to Other Devices
If [USB Mode] is set to [PictBridge(PTP)] in the [Setup] ([IN/OUT]) menu, the
0
camera will be automatically connected to the printer without the [USB Mode]
selection screen being displayed. (l 355)
Do not use any other USB connection cables except the supplied USB
0
connection cables (C–C and A–C).
Take care not to turn off the camera while printing is in progress.
0
When connecting with the printer is not possible, set [USB Power Supply] to
0
[OFF] and then try connecting again. (l 355)
Do not disconnect the USB connection cable while [å] (Cable disconnect
0
prohibit icon) is displayed.
Disconnect the USB connection cable after printing.
0
Turn off the camera and disconnect the USB connection cable before
0
removing the card from the camera. Otherwise, the recorded data may be
damaged.
To print images with paper size and layout settings not supported by the
0
camera, set the [Paper Size] and [Page Layout] to [{] and then select the
desired settings on the printer.
(For details, refer to the operating instructions for your printer.)
If a yellow [¥] is displayed during printing, the camera is receiving an error
0
message from the printer.
After printing finishes, check that there is no problem with the printer.
If the number of prints is high, the pictures may be printed in batches. In this
0
case, the remaining number of prints indicated may differ from the number set.
When you print RAW images, JPEG images that were recorded at the same
0
time will be printed. If JPEG images were not recorded, printing is not
possible.
Recorded images cannot be printed while you are using the following
0
functions:
– Video recording/[6K/4K Burst]/[Post-Focus]
– [HLG Photo]
444

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lumix s1

Table of Contents