Panasonic Lumix DC-S1 Owner's Manual page 465

Wi-Fi Function
A Wi-Fi connection cannot be established.
Radio waves get disconnected.
Wireless access point is not displayed.
General tips for using a Wi-Fi connection
Use within the communication range of the device to be connected.
0
Usage near devices that utilize the 2.4 GHz frequency such as microwave ovens
0
and cordless telephones may result in the radio wave being lost.
Use the camera at a sufficient distance from these devices.
When the remaining battery level is low, it may not be possible to connect to or
0
maintain communication with other devices.
(A message such as [Communication error] is displayed.)
If you place the camera on a metal table or shelf, the radio waves may be adversely
0
affected. In such cases, you may not be able to establish a connection.
Move the camera away from the metal surface.
Wireless access point
Confirm that the connected wireless access point can be used.
0
Confirm the radio wave conditions of the wireless access point.
0
– Move the camera closer to the wireless access point.
– Change the location and angle of the wireless access point.
Depending on the wireless access point, the radio wave may not be displayed even
0
though it is present.
– Turn off and then on the wireless access point.
– If the wireless channel of the wireless access point cannot be set automatically,
manually set the channel supported by the camera.
– If the wireless access point SSID is set not to broadcast, it may not be detected.
Enter the SSID, and then connect. (l 415)
The camera is not displayed in the Wi-Fi setting screen of the
smartphone.
From the Wi-Fi setting menu on the smartphone, turn off and then on the Wi-Fi
0
function.
17. Materials
465