Chapter 3: Getting started
Entering the provisioning server address
About this task
Use this procedure to enter the provisioning server address where asked to do so. For example,
when the phone is first plugged into the network.
Before you begin
Get the provisioning server address from the system administrator.
Procedure
1. On the Configure Provision Server screen, press one of the following softkeys:
• Config: To enter the provisioning server address.
• Never: To never prompt for the provisioning server address.
• Cancel: To cancel the prompt and display the Log Out screen. You can also press Back
to cancel the prompt and display the Log Out screen.
2. In the Prov Server field, enter the provisioning server address. The address can be in the
form of a numerical IP address or an alphanumeric Fully Qualified Domain Name (FQDN).
Tip:
To enter the dot symbol (.) in the field, press the alphanumeric softkey to toggle to the
alphanumeric mode.
3. Press Save.
The phone reboots.
Logging in to your phone
About this task
Perform this task to log in to your phone.
The phone supports Multiple Device Access (MDA) with which you can register up to 10 SIP
devices with your extension. If you register to multiple devices, you can perform functions, such as
switching to another registered device during an active call or bridging on to calls at multiple
registered devices.
March 2018
Using Avaya J169/J179 IP Phones SIP
Comments on this document? infodev@avaya.com
21