Hardware aNd software INstallatIoN
Before installing this product, see Safety and Regulatory Compliance
Before installing this product, see Safety and Regulatory Compliance
Information on the product CD for important information.
Information on the product CD for important information.
All AP-4900MR-LR units must be installed by a suitably trained profession-
All AP-4900MR-LR units must be installed by a suitably trained profession-
al installation technician or by a qualified installation service.
al installation technician or by a qualified installation service.
To ensure proper grounding, use the hole at the bottom point on the back
To ensure proper grounding, use the hole at the bottom point on the back
of each unit and the provided grounding screws to attach a ground wire of
of each unit and the provided grounding screws to attach a ground wire of
at least 10 AWG stranded to each unit. This wire must be as short as pos-
at least 10 AWG stranded to each unit. This wire must be as short as pos-
sible and must be connected to a low-impedance earth ground. Use proper
sible and must be connected to a low-impedance earth ground. Use proper
wire grounding techniques in accordance with local electric codes.
wire grounding techniques in accordance with local electric codes.
Notes:
▪
Be sure to read the Release Notes file on the product CD as it contains
software version and driver information that may not have been available
when this document was produced.
▪
Equipment is to be used with, and powered by, the power injector provided
or by a power injector that meets these requirements:
–
UL-Listed/ITE (NWGQ)
–
Limited Power Source Output per UL/IEC 60950
–
CE-marked
–
Approved for Power-over-Ethernet
–
Rated output, 48 Vdc/0.42 A
–
Pinout follows 802.3af standard for mid-span devices
Page
IMPORTANT!
IMPORTANT!
IMPORTANT!
IMPORTANT!
WARNING!
WARNING!
Copyright © 2006 Proxim Wireless