Vacon 10 Complete User's Manual page 48

control panel
7.4.4 Parameter menu
In Parameter menu only the Quick setup parameter list is shown as default. By giving
the value 0 to the parameter 17.2, it is possible to open other advanced parameter
groups. The parameter lists and descriptions can be found in chapters 8 and 9.
The following figure shows the parameter menu view:
RE AD Y R U N
RE F
M ON
PA R
SYS
F WD R EV
1 Press OK to enter Pa r. menu
RE AD Y R U N
RE F
M ON
PA R
SYS
F WD R EV
3 Press down button to
browse P3.4
RE AD Y R U N
RE F
M ON
PA R
SYS
F WD R EV
5 Press Up / Down to change value
The parameter can be changed as the Figure 7.5.
Left / Right button is available inside Parameter menu. Pressing Left / Right button
to change the actual parameter to the first parameter of the next group (Example:
any parameter of P1... is displayed -> RIGHT button -> P2.1 is displayed -> RIGHT but-
ton -> P3.1 is displayed ...). After entering the desired group, pressing UP / DOWN
button to select root parameter number, and then press OK button to display the val-
ue of the parameter and also enter edit mode.
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
S TO P A L AR M FA ULT
I/O K EY PA D B US
OK
S TO P A L AR M FA ULT
I/O K EY PA D B US
S TO P A L AR M FA ULT
OK
I/O K EY PA D B US
Figure 7.5: Parameter menu
vacon
RE AD Y R U N S TO P A L AR M
RE F
M ON
PA R
SYS
F WD R EV I/O K EY PA D
Press Right to browse
2
otherPar. group
RE AD Y R U N S TO P A L AR M
RE F
M ON
PA R
SYS
F WD R EV I/O K EY PA D
OK
4 Press OK button to enter
edit mode
6 Press OK to confirm
•
45
FA ULT
B US
FA ULT
B US
7