Vacon 10 Complete User's Manual page 46

control panel
7.4.3 Monitoring menu
RE ADY RU N
RE F
M ON
PAR
SYS
FWD R EV
Press OK to enter
1
Monitoring menu
RE ADY RU N
RE F
M ON
PAR
SYS
FWD R EV
Prsess Down to
3
browse V4.4
RE ADY RU N
RE F
M ON
PAR
SYS
FWD R EV
Monitoring values are actual values of measured signals as well as status of some
control settings. It is visible in Vacon 10 display, but it can not be edited. The moni-
toring values are listed in Table 7.2.
Pressing Left/Right button to change the actual parameter to the first parameter of
the next group, to browse monitor menu from V1.x to V2.1 to V4.1. After entering the
desired group, the monitoring values can be browsed by pressing UP /DOWN button,
as shown in Figure 7.4.
In MON menu the selected signal and its value are alternateing in the display by
pressing OK button.
Note! Turn on drive power, arrowhead of main menu is at MON, V x.x
is displayed in Panel.
The value of "x" is determined by the last show before power
shut down. E.g., it was V4.4, and it is also V4.4 when restart.
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
S TO P ALARM FAULT
I/O K EY PAD BUS
OK
S TO P ALARM FAULT
I/O K EY PAD BUS
S TO P ALARM FAULT
OK
I/O K EY PAD BUS
Figure 7.4: Monitoring menu display
RE ADY RU N S TO P ALARM
RE F
M ON
PAR
SYS
FWD R EV I/O K EY PAD
Press Left/Right to browse
2
other Monitoring groups
RE ADY RU N S TO P ALARM
RE F
M ON
PAR
SYS
FWD R EV I/O K EY PAD
OK
Preess OK the value is
4
displayed
Press OK V4.4 is display
5
•
vacon 43
FAULT
BUS
FAULT
BUS
7