Setting The Flame Intensity; By Thermostat; Programming Time Segments - Kalfire G Series User Instructions

4.8 Setting the flame intensity by
thermostat
The remote control measures the
temperature and the flame intensity is
modulated accordingly. To ensure an
accurate temperature reading, make
sure the remote control is outside of
the fire's radiation range.
1. Select the thermostat programme
as indicated in paragraph Selecting
the thermostat or manual operating
programme on page 18.
2. Press the button with the +or with
the ­so that the temperature indica-
tor on the display starts to flash.
3. Set the desired temperature with the
+ and ­ buttons.
4. Wait for 10 seconds before using the
remote control to save the set tem-
perature.

4.9 Programming time segments

The thermostat function can be com-
bined with a timer programme that
allows for up to three time segments to
be programmed. These are indicated by
switch-on times ON 1, 2, 3 and switch-
off times OFF 1, 2, 3. The set program-
me will run daily.
1. Check if the hand transmitter is set
at the right time (if you are not hap-
py with the time, see: 4.3 Day and
night settings)
2. Press the P button (hold down brie-
fly).
3. Let go of Button P when the time
starts to flash in the top left-hand
corner of the display.
4. Press the right button
19
5. Set the desired temperature with the
6. Confirm by pressing the
7. "TECO" (temperature ECO) will now
8. Set the desired temperature with the
9. Confirm by pressing the
10. Press the right button
11. Use the + and - buttons to set the
12. Confirm by pressing the centre but-
13. "OFF 1" will then appear (this is the first
14. Use the + and - buttons to set the
15. Confirm by pressing the
16. Programme the other times in the
to display
"TCOM" (temperature comfort).
TCOM indicates the maximum
temperature during all set time
segments.
+ or - buttons at increments of 0.5°C.
button).
appear in the display. TECO is the
minimum temperature between the
time segments. This minimum tem-
perature will be maintained all day
with the exception of the set time
segments.
+ or - buttons at increments of 0.5°C.
button).
flashing time in hours and minutes
appears in the top left-hand corner,
while "ON 1" appears in the middle
of the display (this is the first "on"
time).
first "on" time at increments of
15 minutes.
ton if you are happy with
the time.
"Out" time).
first "out" time, at increments of
15 minutes.
three segments in this way; should
you not require all time segments,
these other segments should be set
(centre
(centre
, so that a
button.