Setting Day And Time; Checking Transmission Strength - Kalfire G Series User Instructions

12
11
10
9
8
7
5. The flame is ignited if the icon is
alight, if this icon is flashing one of
the following notifications requires
your attention: heat adequacy, igni-
tion attempt or reignition attempt.
6. The ECO mode is activated.
7. Batteries are flat.
8. Room temperature and other
notifications such as disruptions.
9. Warning signals related to
disruptions.
10. Time segments
11. Thermostat mode.
12. Manual programme (default mode).
17
1 2
Buttons:
a. + and - buttons
b. Left button
c. Centre button
d. On/off button
3
e. Parameter configuration button P

4.3 Setting day and time

Setting day and time.
Carry out the following steps to change
4
the day and time settings:
5
1. Hold down the P button until the
6
time display starts flashing.
2. Change the hour with the +or­
a.
button and confirm the change by
b.
pressing the centre button.
The minutes will then begin to flash.
c.
3. Change the minutes with the + or ­
button and confirm the change by
d.
pressing the centre button. The
number indicating the day of the
e.
week will then begin to flash
(1 = Monday).
4. Change the day with the +or­button
and confirm the change by pressing
the centre button.
5. To exit the parameters menu, press P.
6. Wait for 30 seconds while the infor-
mation is transmitted.

4.4 Checking transmission strength

Carry out the following steps in order
to modulate transmission strength bet-
ween gas fire and the remote control.
1. Press P until the transmission
strength flashes at the top left of the
display.
2. Press the right button until RFCK
appears in the display.
and right