Table of Contents
Advertisement
10.3.4 Configuring a multipoint adjustment
Bosch Motorsport
9.
Click 'OK' when done.
The channel is inserted into the C 60 Project Tree.
Channel is
linked to
ANA05
Available measurements for channel:
Measurement label
raw_name
raw_name_fi
name
name_fi
Example: Measurement of wheel force
– Physical property 'wheel force' not directly measureable
– Load transfer through suspension kinematics
– Physical value at sensor position defined by vehicle
– Curve definition by online adjustment at vehicle
1.
Click on 'Measurement Sources' in the Toolbox.
2.
Expand the list of 'I/O Channels' by clicking on '+' in the C 60 Project Tree.
3.
Drag the 'Multipoint Adjustment' analog signal source from the Toolbox and drop it
on the desired analog input channel in the C 60 Project Tree.
4.
A 'Multipoint Adjustment Wizard' opens.
5.
To activate the internal pullup-resistor, check the box.
Data Logger C 60
Analog and Frequency Inputs | 10
Input pin
Characteristic
Pull-up
curve for
resistor is
sensor
activated
Function
mV value of sensor
filtered mV value of sensor
physical value of sensor
filtered physical value
Adjustment
is disabled
43 / 108
Advertisement
Table of Contents
