Table of Contents
Advertisement
11 | Online Measurement
11.1 Achieving an online connection
11.1.1 Set up the PC for access to the Unit
11.1.2 Going online
11.1.3 Configuration download
70 / 108
11 Online Measurement
C 60 configuration
– System configuration (channel + display configuration, CAN I/O, PWM Out, etc.) is
stored in the C 60
– Use RaceCon to create and download configuration from the PC to C 60
– Communication interface: Ethernet
– Communication protocol: XCP
Online measurement + calibration
– System status and diagnosis
– Check and calibrate sensors in the vehicle
– Live display of sensor values on the PC
– Use RaceCon for diagnosis, online measurement and calibration
– Communication interface: Ethernet
– Communication protocol: XCP
1.
Switch off local firewall on the PC.
2.
Set IP Configuration for the Ethernet interface to 'automatic configuration' (DHCP).
See chapter 'Setting up the network interface' for details.
3.
Start RaceCon.
4.
Establish the Ethernet connection to the vehicle.
5.
Power on the vehicle.
Click 'OK to download RaceCon configuration to C 60.
The download starts.
A green dot and background at the device in the project view and the C 60 Project Tree
indicate a successful download and system consistency.
If the system's configuration in RaceCon has been changed, the dot and background be-
comes yellow and a configuration download is necessary.
1.
Right-click on C 60 in the C 60 Project Tree.
Data Logger C 60
Bosch Motorsport
Advertisement
Table of Contents
