Table of Contents
Advertisement
9 | CAN Bus
9.3.3 Edit CAN Message Multiplexer settings
9.3.4 Export RaceCon CAN configuration
34 / 108
In this dialogue additional settings are possible:
– Representation: Also a Bitwise CAN signal can be defined. Please define position and
length in this case.
– Quantization: Physical values can be calculated by entering Factor/Offset. Signed and
unsigned is optional.
1.
Click "Use multiplexer", the Option "Hide" opens the multiplexer settings.
Representation: Choose Byte or Bit Type of multiplexer
Start, Length: Define start position and length of multiplexer (Byte or Bitwise possible)
Endianness: Define Byte order (Little Endian –LB, HB, Big Endian –HB, LB)
1.
Right-click on CAN Output of desired bus (CAN1 or CAN2).
2.
Select 'Export...' from menu. The 'Export Selection' window opens.
3.
Specify the filename.
4.
Click 'OK' when done.
Data Logger C 60
Bosch Motorsport
Advertisement
Table of Contents
