Table of Contents
Advertisement
8 | Starting up the C 60
8.1.1 Setting up the network interface
8.1.2 About RaceCon
22 / 108
8 Starting up the C 60
8.1 Before starting
Install the software required C 60 operation. It is developed for Windows 2000/XP/Vista/7.
Following software versions are used in this manual:
– C 60 setup, configuration and calibration: RaceCon 2.1.0
– Measurement data analysis: WinDarab V7
Set up the 100 Mbit Ethernet connection to the C 60.
– All three Ethernet ports of C 60 are internally connected by a network switch
– All Ethernet ports have 'cable auto crossover' functionality
Minimum wiring loom of the Life connector (red):
Pin
Pin 1+2+3
Pin 4+5
Pin 6
Pin 7
Pin 8
Pin 9
Pin 10
The C 60 contains a DHCP server, network addresses can be assigned automatically to the
configuration PC. The IP address of C 60 is 10.10.0.207.
1.
Switch off the PC's firewall.
2.
Set up the PC's network interface as shown in the screenshots.
RaceCon is an all integrated software tool for configuration and calibration of Bosch
Motorsport hardware products. It is used to set up, configure and calibrate the C 60.
For better understanding, Bosch Motorsport offers a video tutorial that explains many
functions of RaceCon. The video tutorial is available in the 'Software Download' section of
www.bosch-motorsport.com.
Data Logger C 60
Description
12 V supply voltage
GND supply voltage
Ethernet Tx+
Ethernet Tx-
Ethernet Rx+
Ethernet Rx-
Ethernet Screen
Select
'Internet
Protocol
(TCP/IP)'
Click
'Properties'
Select 'Obtain
an IP address
automatically'
Click 'OK'
when done
Bosch Motorsport
Advertisement
Table of Contents
