Jungheinrich DFG 425 Operating Instructions Manual page 67

Transporting a load
F
If the load is stacked up so high that it
affects forward visibility, then reverse.
– Gently accelerate with the accelerator
pedal (21) and slowly brake with the
slow travel / brake pedal (20). Be
ready to brake at all times.
– Adapt your travel speed to the
conditions of the route and the load
you are transporting.
– Watch out for other traffic at crossings
and passageways.
– Only drive with a lookout at blindspots
F
On slopes and inclines always carry the
load facing uphill, never approach at an
angle or turn.
M
Never reverse at full speed or at just 5
km/h (or less).
Depositing a load
– Drive the truck carefully up to the rack.
– Set the travel direction switch (27) to
neutral.
– Engage the parking brake lever (16).
– Raise the load fork to the correct
height for the rack space.
– Set the mast vertical.
– Set the travel direction switch (27) to
forward and release the parking brake
lever (16).
– Carefully enter the load into the rack
space.
– Slowly lower the load until the load
fork is free.
M
Avoid placing the load down suddenly to
avoid damaging the load and the load
lifting device.
E 32
20
27
.
16
27
21