Jungheinrich DFG 425 Operating Instructions Manual page 65

Raising a load
– Carefully approach the load to be
raised.
– Set the travel direction switch (27) to
neutral.
– Tighten the parking brake lever (16).
– Raise the load fork to the correct
height for the load.
– Set the travel direction switch to
forward and release the parking
brake.
– Carefully enter the load until ideally it
touches the fork shank.
F
At least two thirds of the length of the
load fork must extend into the load.
– Set the travel direction switch (27) to
neutral and apply the parkingbrake
lever (16).
– Raise the fork carriage until the load is
resting freely on the load fork.
– Set the travel direction switch to
reverse and release the parking
brake.
F
It is forbidden to lift people with the lifting
device.
F
Make sure you have enough free space
to reverse.
– Reverse carefully and slowly until the
load is outside the storage area.
E 30
16
27