Table of Contents
Advertisement
Firmware Upgrade Instructions, continued
Procedure
(continued)
STEP 4: Verify the firmware update.
D-8
3.23. Once the file has been uploaded, click on Continue to proceed.
3.24. When firmware upload procedure is complete, the screen will return to
the Home page. Close the Internet Explorer program to exit.
4.1. Restart the unit by turning the power switch to OFF then turn back to ON.
4.2. The Status LED should blink every 16 seconds if the firmware upload
procedure was done correctly.
NOTE: The number of blinks correspond to the number of installed
modules.
4.3. Open Internet Explorer and type in 192.168.0.20 in the IP address bar.
Press return to display the Encore Series Home page.
Continued on next page
Advertisement
Table of Contents
