Procedure
(continued)
3.7. When done selecting the file to upload, click on Continue and wait until
the following screen appears.
3.8. Click on Continue to proceed.
3.9. If a Calibration Failed page is displayed, repeat the process from Step
3.1.
NOTE: If several attempts fail, turn the power switch OFF then turn back
ON, and repeat the process from Step 3.1.
3.10. If the file was loaded properly, continue the procedure as follows.
3.11. Click on the
Options screen will appear.
3.12. Click on the Upload Firmware option, and the following screen will
appear.
APPENDIX D/ 61000 System Firmware Upgrade
icon found on the left side bar. The Factory Debug
Continued on next page
D-5