Starting Bio X For The First Time - Cellink BIO X User Manual

3.4 Starting BIO X for the first time

When you start BIO X for the first time, you will be prompted to review a license agreement. After
accepting the agreement, you will be taken to the home screen.
1
1. Standby – Tap to put BIO X in standby mode. To start BIO X from standby
mode, turn off the power using the power switch on the back, wait 30
seconds and turn it back on.
2. Status bar – Symbols in this area will alert you of potential hazards such
as heated surfaces or active UV lights (see the symbols below.) Use caution
when these symbols are displayed.
3. Bioprint - Tap to start a 3D bioprinting process
4. Droplet Print - Tap to access the droplet menu. Select the well plate to print droplets.
5. Clean Chamber - Tap to toggle the Clean Chamber settings, or to start UV sterilization.
6. Utilities – Tap to open the utilities menu. The utilities menu
contains advanced settings and troubleshooting functions.
3
5
2
4
6
21