The Restart Screen - ZyXEL Communications AMG1302-T10A User Manual

If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default device IP address (192.168.1.1). See
Appendix A on page 231
If the upload was not successful, the following screen will appear. Click Return to go back to the
Configuration screen.
Figure 121 Configuration Upload Error
Reset to Factory Defaults
Click the Reset button to clear all user-entered configuration information and return the Device to
its factory defaults. The following warning screen appears.
Figure 122 Reset Warning Message
Figure 123 Reset In Process Message
You can also press the RESET button on the rear panel to reset the factory defaults of your Device.
Refer to Section 1.7 on page 19

22.4 The Restart Screen

System restart allows you to reboot the Device remotely without turning the power off. You may
need to do this if the Device hangs, for example.
AMG1302-T10A User's Guide
for details on how to set up your computer's IP address.
for more information on the RESET button.
Chapter 22 Tools
221