ZyXEL Communications AMG1302-T10A User Manual page 225

The following table describes the fields in this screen.
Table 99 Maintenance > Diagnostic > DSL Line
LABEL
ATM Status
ATM Loopback
Test
AMG1302-T10A User's Guide
DESCRIPTION
Click this to view your DSL connection's Asynchronous Transfer Mode (ATM)
statistics. ATM is a networking technology that provides high-speed data transfer.
ATM uses fixed-size packets of information called cells. With ATM, a high QoS
(Quality of Service) can be guaranteed.
The (Segmentation and Reassembly) SAR driver translates packets into ATM cells.
It also receives ATM cells and reassembles them into packets.
These counters are set back to zero whenever the device starts up.
inPkts is the number of good ATM cells that have been received.
inDiscards is the number of received ATM cells that were rejected.
outPkts is the number of ATM cells that have been sent.
outDiscards is the number of ATM cells sent that were rejected.
inF4Pkts is the number of ATM Operations, Administration, and Management
(OAM) F4 cells that have been received. See ITU recommendation I.610 for more
on OAM for ATM.
outF4Pkts is the number of ATM OAM F4 cells that have been sent.
inF5Pkts is the number of ATM OAM F5 cells that have been received.
outF5Pkts is the number of ATM OAM F5 cells that have been sent.
openChan is the number of times that the Device has opened a logical DSL
channel.
closeChan is the number of times that the Device has closed a logical DSL
channel.
txRate is the number of bytes transmitted per second.
rxRate is the number of bytes received per second.
Click this to start the ATM loopback test. Make sure you have configured at least
one PVC with proper VPIs/VCIs before you begin this test. The Device sends an
OAM F5 packet to the DSLAM/ATM switch and then returns it (loops it back) to the
Device. The ATM loopback test is useful for troubleshooting problems with the
DSLAM and ATM network.
Chapter 23 Diagnostic
225